Sunday is my parents’ day off, so the day always begins early. Ran errands for a while. When we got back home, I washed both the car and reclaimed a screen at the same time. Viva la pressure washer! Bought anchors to install overhead lighting (see above). Hung out with Molly one more time because her flight back to Northampton got delayed until tomorrow morning.

After the transparent white layer.

I added an extra green layer because it was basically washed out by the white. I’m going to highlight some of the lines and then that’s it.

I still have to finish the print exchange print. I keep putting it off because I can’t settle on just one image for this last layer. I should really make up my mind. It’s due on the 15th anyway…

Tomorrow is going to be crazy. Here’s a run down of what I have to do:
- call Roeder and see where in the world my Easisolv 5 is
- call Mazen at HH and see if I can come in and use the mat cutter
- buy some small frames for my etchings and frame sections for the large square piece, buy mat board?
- run by Tulsa Plastics to buy plexi
- go to HH/Jenks to cut mats
- quickly assemble frames
- get my ass downtown to hang the New Directions show!
- $4 burritos at El Guapos?

It’s going to be a long day.